Kia Forte: Scheduled maintenance service / Maintenance Under Severe Usage Conditions - Non Turbo Models

Kia Forte 2019-2024 (BD) Owner's Manual / Maintenance / Scheduled maintenance service / Maintenance Under Severe Usage Conditions - Non Turbo Models

The following items must be serviced more frequently on cars normally used under severe driving conditions. Refer to the chart below for the appropriate maintenance intervals.

R : Replace
I : Inspect and, after inspection, clean, adjust, repair or replace if necessary

Severe driving conditions

A- Repeatedly driving short distances of less than 8 km (5 miles) in normal temperature or less than 16 km (10 miles) in freezing temperature
B- Extensive engine idling or low speed driving for long distances
C-Driving on rough, dusty, muddy, unpaved, graveled or saltspread roads
D-Driving in areas using salt or other corrosive materials or in very cold weather
E-Driving in heavy dust conditions
F - Driving in heavy traffic areas
G- Driving on uphill, downhill, or mountain roads repeatedly
H-Towing a Trailer, or using a camper, or roof rack
I -Driving as a patrol car, taxi, other commercial use or vehicle towing
J - Driving over 170 km/h (106 mph)
K-Frequently driving in stop-and-go conditions

    The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for all vehicle emission services to protect your warranty.

    The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for all vehicle emission services to protect your warranty.

    Other information:

    Kia Forte 2019-2024 (BD) Owner's Manual: Stop and tail lamp (LED type) bulb replacement (Rear combination lamp Type B)

    If the stop and tail lamp (LED) (1,2,3) does not operate, have the vehicle checked by an authorized Kia dealer. The LED lamp cannot be replaced as a single component because it is an integrated unit. The LED lamp has to be replaced with the unit.

    Kia Forte 2019-2024 (BD) Owner's Manual: High mounted stop lamp (bulb type) bulb replacement

    1. Open the trunk lid. 2. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 3. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket.

    Categories

     
    Copyright © 2026 www.kiforte.com - 0.0146