
■ Type A

■ Type B
(1) Side repeater lamp (LED type)
(2) Side repeater lamp (bulb type)
■ Rear combination lamp - Type A ■ Rear combination lamp - Type B (1) Stop and tail lamp (Bulb type) (2) Tail lamp (Bulb type) (3) Side marker (Bulb type) (4) Stop lamp (LED type) (5,6) Tail lamp (LED type) (7) Side marker (LED type) ■ Rear turn signal lamp / Back up lamp ■ License plate lamp (8) Rear turn signal lamp (Bulb type) (9) Back Up lamp (Bulb type) (10) License plate lamp (Bulb type) ■ High mounted stop lamp (11) High mounted stop lamp (Bulb or LED type)
1. Open the hood. 2. Remove the headlamp bulb cover by turning it counterclockwise. 3. Disconnect the headlamp bulb socket-connector. 4. Remove the bulb-socket from the headlamp assembly by turning the bulb-socket counterclockwise until the tabs on the bulb-socket align with the slots on the headlamp assembly.
For best battery service Keep the battery securely mounted. Keep the battery top clean and dry. Keep the terminals and connections clean, tight, and coated with petroleum jelly or terminal grease. Rinse any spilled electrolyte from the battery immediately with a solution of water and baking soda.
Bulb replacement precaution Please keep extra bulbs on hand with appropriate wattage ratings in case of emergencies. Refer to the "Bulb Wattage" section in Chapter 8. When changing lamps, first turn off the engine at a safe place, firmly apply the parking brake and detach the battery’s negative (-) terminal.