Kia Forte: Light bulbs / Stop and tail lamp/side marker
(Bulb type) bulb replacement
(Rear combination lamp Type A)
![](images/stop_and_tail_lamp_side_marker_bulb_type_bulb_replacement_rear_combination_lamp_type_a_-369/1/forte_600.png)
![](images/stop_and_tail_lamp_side_marker_bulb_type_bulb_replacement_rear_combination_lamp_type_a_-369/1/forte_085.png)
1. Open the trunk lid.
2. Open the service cover.
3. Remove the nuts from the vehicle.
![](images/stop_and_tail_lamp_side_marker_bulb_type_bulb_replacement_rear_combination_lamp_type_a_-369/1/forte_471.png)
![](images/stop_and_tail_lamp_side_marker_bulb_type_bulb_replacement_rear_combination_lamp_type_a_-369/1/forte_042.png)
4. Remove the rear combination
lamp assembly from the body of
the vehicle.
5. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
6. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
7. Insert a new bulb by inserting it
into the socket and rotating it until
it locks into place.
8. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
9. Install the rear combination lamp
assembly to the body of the vehicle.
10. Install the service cover.
1. Remove the lamp assembly from
the vehicle by prying the lens and
pulling the assembly out.
2. Disconnect the bulb electrical connector.
3. Separate the socket and the lens
parts by turnin ...
1. Open the trunk lid.
2. Loosen the retaining screw of the
trunk lid cover. Remove the trim
mounting clip and take off the
cover.
3. Remove the socket from the
assembly by turning the ...
Other information:
CAUTION - Conductors
To prevent damage to the conductors
bonded to the inside
surface of the rear window,
never use sharp instruments or
window cleaners containing
abrasives to clean the window.
If you want to defrost and defog the
front windshield, refer to “Windshield
defrosting ...
The driver may choose to only use
the cruise control mode (speed control
function) by doing as follows:
1. Turn the smart cruise control system
on (the cruise indicator light
will be on but the system will not
be activated).
2. Push the distance to distance
switch for more than 2 s ...