Kia Forte: LKA operation / LKA activation

Kia Forte 2019-2021 (BD) Owners Manual / Driving your vehicle / Lane Keeping Assist (LKA) system / LKA operation / LKA activation

To see the LKA screen on the LCD display in the cluster, Tab to the ASSIST mode ().
For further details, refer to the [menu settings] section in Chapter 4.
After LKA is activated, if both lane markers are detected, vehicle speed is over 64 km/h (40 mph) and all the activation conditions are satisfied, a green steering wheel indicator will illuminate, and the steering wheel will be controlled.

WARNING

The Lane Keeping Assist system is a system to help prevent the driver from leaving the lane. However, the driver should not rely solely on the system and should always check the road conditions while driving.

If the speed of the vehicle is over 64 km/h (40 mph) and the system detects lane markers, the color changes from gray to white

When the conditions below are met, LKA will be enabled to assist steering.

Vehicle speed is above 64 km/h (40 mph).
Both lane markers are detected by LKA.
The vehicle is between the lane markers.

If LKA can assist steering, a green steering wheel indicator will illuminate.

LKA operation

To activate/deactivate the LKA: With the ignition switch in the ON position, press the LKA button located on the instrument panel on the lower left hand side of the driver. The indicator in ...

Warning

If the vehicle leaves a lane, the lane marker you cross will blink on the LCD display. If the vehicle moves out of its lane because the steering torque for assistance is insufficient, the l ...

Other information:

Kia Forte 2019-2021 (BD) Owners Manual: Mode selection

The mode selection knob controls the direction of the air flow through the ventilation system. Air can be directed to the floor, dashboard outlets, or windshield. Five symbols are used to represent Face, Bi-Level, Floor, Floor-Defrost and Defrost air position. Face-Level (B, D, F) ...

Kia Forte 2019-2021 (BD) Owners Manual: One time driving information mode (For type B, C cluster)

The vehicle will display Driving Information once per once per each ignition cycle. Fuel efficiency is calculated after the vehicle has run for more than 300 meters (0.18 miles). The Driving Information will be reset 4 hours after the ignition has been turned off. So, if the ...