Kia Forte: RCCW (Rear Cross-Traffic Collision Warning) / Operating conditions to operate

• Go to “User Settings → Driving Assist and select Rear Cross Traffic Collision Warning” on the LCD display.

The system will turn on and standby to activate. If you deactivate this function in the cluster, the system will stop.

✽ NOTICE

  • If the vehicle is turned off and on again, the RCCW system will return to the state right before the vehicle was turned off.
  • The system will activate when vehicle speed is below 10 km/h (6.2 mph) and with the shift lever in R (Reverse).
  • The Rear Cross-Traffic Collision Warning (RCCW) detecting range is approximately 0.5 m ~ 20 m (1 ft ~ 65 ft) in the direction of both lateral sides of the car.
    An approaching vehicle will be detected if its vehicle speed is within 4 km/h ~ 36 km/h (2.5 ~ 22.5 mph).
    Note that the detecting range may vary under certain conditions. As always, use caution and pay close attention to your surroundings when backing up your vehicle.

    When your vehicle moves backwards from a parking position, the sensor detects approaching vehicles to the left or right side and gives information to the driver.

    If the vehicle detected by the sensors approaches your vehicle, the warning chime will sound, the warning light on the outside rearview mirror will blink and a message will appear on the LCD display.

    Other information:

    Kia Forte 2019-2024 (BD) Owner's Manual: Checking the tire inflation pressure

    1.After driving approximately 7~10 km (4~6 miles) or about 10 minutes, stop at a suitable location. 2.Connect the filling hose (3) of the compressor (clip mounted side) directly and then connect the filling hose (3) (opposite side) to the tire valve.

    Kia Forte 2019-2024 (BD) Owner's Manual: Room lamp (LED type), Vanity mirror lamp bulb replacement

    Room lamp (LED type) bulb replacement If the room lamp (LED) (1) does not operate, have the vehicle checked by an authorized Kia dealer. The LED lamp cannot be replaced as a single component because it is an integrated unit. The LED lamp has to be replaced with the unit.

    Categories

     
    Copyright © 2026 www.kiforte.com - 0.0116