Kia Forte: Light bulbs / Headlamp (Low beam) bulb
replacement (Headlamp Type
A,B)

1. Open the hood.
2. Remove the headlamp bulb cover
by turning it counterclockwise.
3. Disconnect the headlamp bulb
socket-connector.
4. Remove the bulb-socket from the
headlamp assembly by turning the
bulb-socket counterclockwise until
the tabs on the bulb-socket align
with the slots on the headlamp
assembly.
5. Install a new bulb-socket assembly
in the headlamp assembly by
aligning the tabs on the bulb-socket
with the slots in the headlamp
assembly. Push the bulb-socket
into the headlamp assembly and
turn the bulb-socket clockwise.
6. Connect the headlamp bulb socket-
connector.
7. Install the headlamp bulb cover by
turning it clockwise.
Headlamp bulb

WARNING - Halogen
bulbs
- Halogen bulbs contain pressurized
gas that will produce
flying pieces of glass if broken.
- Always handle them carefully,
and avoid scratches and abrasions.
If the bulbs are lit, avoid
contact with liquids. Never
touch the glass with bare
hands. Residual oil may cause
the bulb to overheat and burst
when lit.
A bulb should be operated
only when installed in a headlight.
- If a bulb becomes damaged or
cracked, replace it immediately
and carefully dispose of it.
- Wear eye protection when
changing a bulb. Allow the
bulb to cool down before handling
it.
■ Type A
■ Type B
(1) Side repeater lamp (LED type)
(2) Side repeater lamp (bulb type) ...
1. Open the hood.
2. Remove the headlamp bulb cover
by turning it counterclockwise.
3. Remove the bulb-socket from the
headlamp assembly by turning the
bulb-socket counterclockwise until
t ...
Other information:
Engine room compartment fuse panel
Engine room compartment fuse panel
Relay
Engine compartment fuse panel
(Battery terminal cover)
✽ NOTICE
Not all fuse panel descriptions in
this manual may be applicable to
your vehicle. It is accurate at the
time of printing. When you ...
1. Turn the ignition switch and all
other switches off.
2. Remove the fuse panel cover by
pressing the tab and pulling the
cover up.
3. Check the removed fuse; replace it
if it is blown. To remove or insert
the fuse, use the fuse puller in the
engine compartment fuse panel.
4. Push ...