Kia Forte: Battery / Recharging the battery
Your vehicle has a maintenance-free,
calcium-based battery.
- If the battery becomes discharged
in a short time (because, for example,
the headlamps or interior
lamps were left on while the vehicle
was not in use), recharge it by
slow charging (trickle) for 10 hours.
- If the battery gradually discharges
because of high electric load while
the vehicle is being used, recharge
it at 20-30A for two hours.
When recharging the battery,
observe the following precautions:
- The battery must be removed from
the vehicle and placed in an area
with good ventilation.
- Do not allow cigarettes, sparks, or
flame near the battery.
- Watch the battery during charging,
and stop or reduce the charging
rate if the battery cells begin
gassing (boiling) violently or if the
temperature of the electrolyte of
any cell exceeds 49°C (120°F).
- Wear eye protection when checking
the battery during charging.
- Disconnect the battery charger in
the following order.
1. Turn off the battery charger main
switch.
2. Unhook the negative clamp from
the negative battery terminal.
3. Unhook the positive clamp from
the positive battery terminal.
- Before performing maintenance or
recharging the battery, turn off all
accessories and stop the engine.
- The negative battery cable must be
removed first and installed last
when the battery is disconnected.
For best battery service
Keep the battery securely mounted.
Keep the battery top clean and dry.
Keep the terminals and connections
clean, tight, and coated with
petroleum jelly or terminal grease.
The following should be reset after
the battery has been discharged or
the battery has been disconnected.
Auto up/down window
(See Chapter 4)
Sunroof (See Chapter 4)
Trip computer (See Chapter 4)
Climate control system
(See Chapter 4)
Driver position memory system
(See Chapter 3)
Audio (See Chapter 4)
Other information:
1. Detach the speed restriction label
(1) from the sealant bottle (2), and
place it in a highly visible place
inside the vehicle such as on the
steering wheel to remind the driver
not to drive too fast.
2. Filling the sealant: Strictly follow
the specified sequence, otherwise
the sealant may escape under
high pressure.
If the position lamp + DRL (LED) (1)
does not operate, have the vehicle
checked by an authorized Kia dealer.
The LED lamp cannot be replaced
as a single component because it is
an integrated unit. The LED lamp has
to be replaced with the unit.