Kia Forte: RCCW (Rear Cross-Traffic Collision Warning) / Warning type

If the vehicle detected by the sensors approaches your vehicle, the warning chime will sound, the warning light on the outside rearview mirror will blink and a message will appear on the LCD display.

✽ NOTICE

  • The warning chime will turn off:
    - When the detected vehicle moves out of the sensing area or
    - If your vehicle is moved away from the detected vehicle or
    - When the vehicle is right behind your vehicle or
    - When the vehicle is not approaching your vehicle or
    - When the other vehicle slows down.
  • The system may not operate properly due to other factors or circumstances. Always pay attention to your surroundings.
  • If the sensing area near the rear bumper is blocked by either a wall, barrier, or parked vehicle, the system sensing area may be reduced.

WARNING

  • When the BCW system is activated, the warning light on the outside rearview mirror will illuminate whenever a vehicle is detected at the rear side by the system. To avoid accidents, do not focus only on the warning light and neglect to see the surroundings of the vehicle.
  • Drive safely even though the vehicle is equipped with a BCW (Blind-Spot Collision Warning) system. Do not solely rely on the system but check the blind spot area for yourself before changing lanes. The system may not alert the driver in some conditions, so always check the surroundings while driving.
  • The Blind-Spot Collision Warning system (BCW) and Rear Cross-Traffic Collision Warning (RCCW) are not substitutes for proper and safe driving practices. Always drive safely and use caution when changing lanes or backing up your vehicle.The Blind- Spot Collision Warning system (BCW) may not detect every object alongside the vehicle.

CAUTION

  • The system may not work properly if the bumper has been replaced or if repair work has been done near the sensor.
  • The detection area differs according to the width of the road. If the road is narrow, the system may detect other vehicles two lanes away.
  • Also, if the road is very wide, the system may not detect other vehicles in the next lane.
  • The system might be turned off due to strong electromagnetic waves.

    • Go to “User Settings → Driving Assist and select Rear Cross Traffic Collision Warning” on the LCD display. The system will turn on and standby to activate.

    The sensor may be limited when the conditions below exist. If there is a problem with the BCW system, a warning message will appear and the light on the switch will turn off.

    Other information:

    Kia Forte 2019-2024 (BD) Owner's Manual: Tail lamp (inside) (Bulb type) bulb replacement (Rear combination lamp Type A)

    1. Open the trunk lid. 2. Loosen the retaining screw of the trunk lid cover. Remove the trim mounting clip and take off the cover. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

    Kia Forte 2019-2024 (BD) Owner's Manual: Stop and tail lamp (LED type) bulb replacement (Rear combination lamp Type B)

    If the stop and tail lamp (LED) (1,2,3) does not operate, have the vehicle checked by an authorized Kia dealer. The LED lamp cannot be replaced as a single component because it is an integrated unit. The LED lamp has to be replaced with the unit.

    Categories

     
    Copyright © 2026 www.kiforte.com - 0.0092