Kia Forte: Warning lights / Sunroof open, Ice , Forward Collision-avoidance Assist warning lights
Sunroof open warning light
This warning light blinks:
- If the driver removes the ignition key and opens the driver-side door when the sunroof is not fully closed, the warning chime will sound for a few seconds and a warning light will appear on the LCD display.
Close the sunroof securely when leaving your vehicle.
Ice Warning Light
This warning light blinks 5 times and then illuminates, and a warning chime also sounds 1 time:
• When the temperature on the Outside Temperature Gauge is below approximately 4OC (39.2OF) with the ignition switch or Engine Start/Stop button in the ON position.
✽ NOTICE
If the ice warning light appears while driving, you should drive more attentively and safely refraining from over-speeding, rapid acceleration, sudden braking or sharp turning, etc.
Forward Collision-avoidance Assist Warning light (FCA, if equipped)
This indicator light illuminates:
- When there is a malfunction with the FCA.
In this situation, have the vehicle inspected by an authorized Kia dealer.
LED Headlamp, Washer Fluid, Hood open Warning
Lights
LED Headlamp Warning
Light
This warning light illuminates:
Once you set the Engine Start/Stop
Button to the ON position.
- It illuminates for approximately 3
seconds and then goes of ...
Master Warning Mode
• This warning light informs the driver
of the following situations:
- LED head lamp malfunction (if
equipped)
- Forward Collision-Avoidance
Assist malfunction (if equipped)
- Blind-Spo ...
Other information:
Kia Forte 2019-2021 (BD) Owners Manual: DCT warning messages
■ Type A ■ Type B This warning message is displayed when the vehicle is driven slowly on a grade and the vehicle detects that the brake pedal is not applied. Steep grade Driving up hills or on steep grades: To hold the vehicle on an incline, use the foot brake or the parki ...
Kia Forte 2019-2021 (BD) Service Manual: Room Lamp
Repair procedures Removal When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. 1. Disconnect the negative (-) batt ...