Kia Forte: Power Train / Manual Transaxle Oil
Repair procedures
Manual Transaxle Oil Level Check
1. |
Uplift the vehicle with lift.
|
2. |
Remove the under cover.
Nu 2.0 MPI (Refer to Engine Mechanical System - "Engine Room Under Cover")
Gamma 1.6 MPI (Refer to Engine Mechanical System - "Engine Room Under
Cover")
|
3. |
Remove the oil filler plug (A).
[GAMMA 1.6 MPI]
[NU 2.0 MPI]
|
4. |
Check the condition of the oil and make sure that it is at the proper
level (A).
|
5. |
Install the oil filler plug (A).
Tightening torque :
58.9 - 78.5 N·m (6.0 - 8.0 kgf·m, 43.4 - 57.8 lb·ft)
|
[GAMMA 1.6 MPI]
[NU 2.0 MPI]
The existing oil filler plug gasket must be replaced with new
one. (Do not reuse it.)
|
|
Repair procedures
Inspection
Visually check the fuel lines for cracks, leakage, loose connections, deformation
or tank band looseness. ...
Repair procedures
Inspection
[New U 1.6 TCI]
1.
Remove the engine cover.
(Refer to Engine Mechanical System - "Engine Cover")
2 ...
Other information:
Repair procedures
Removal
1.
Remove the multifunction switch.
(Refer to Body Electrical System - "Multifunction Switch")
Installation
1.
Install in the reverse order of removal.
Inspection
Multifunc ...
The sensor may be limited when the
conditions below exist.
If there is a problem with the BCW
system, a warning message will
appear and the light on the switch
will turn off. The system will turn off
automatically.
One or both of the sensors on the
rear bumper is blocked by dirt, ...