Room lamp

■ Type A

■ Type B
•
: The light stays on at all
times.
Map lamp

■ Type A

■ Type B
• Press the lens (1) to turn ON the map lamp.
To turn the map lamp OFF, press the lens (1) again.
• (2)
: DOOR mode
- The map lamp and room lamp
come on when a door is opened.
The lamps go out after approximately
30 seconds.
- The map lamp and room lamp
come on for approximately 30 seconds
when doors are unlocked
with a transmitter or smart key as
long as the doors are not opened.
- The map lamp and room lamp will
stay on for approximately 20 minutes
if a door is opened with the
ignition switch in the ACC or
LOCK/OFF position.
- The map lamp and room lamp will
stay on continuously if the door is
opened with the ignition switch in
the ON position.
- The map lamp and room lamp will
go out immediately if the ignition
switch is changed to the ON position
or all doors are locked.
- To turn off the DOOR mode, press
the DOOR button (2) once again
(not pressed).
✽ NOTICE
The DOOR mode and ROOM mode can not be selected at the same time.
Front Room Lamp:
• Type A
(3): Press this switch to turn the front and rear room lamps on.
(4): Press this switch to turn the front and rear room lamps off.
• Type B
(3): Press this switch to turn the front and rear room lamps on and off.
Do not use the interior lights for extended periods when the engine is not running as this may cause battery discharge. WARNING - Interior Lights Do not use the interior lights when driving in the dark.
The trunk room lamp comes on when the trunk is opened. ✽ NOTICE The trunk room lamp comes on as long as the trunk lid opens. To prevent unnecessary battery drain, close the trunk lid securely after using the trunk.
Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the vehicle is being driven in severe conditions, more frequent oil and filter changes are required. Drive belts Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation, and rep
1. Open the hood. 2. Remove the headlamp bulb cover by turning it counterclockwise. 3. Remove the bulb-socket from the headlamp assembly by turning the bulb-socket counterclockwise until the tabs on the bulb-socket align with the slots on the headlamp assembly.