Kia Forte: Electronic stability control (ESC) / ESC operation

ESC ON condition

  • When the ignition is turned ON, ESC and ESC OFF indicator lights illuminate for approximately 3 seconds, then ESC is turned on.
  • Press the ESC OFF button for at least half a second after turning the ignition ON to turn ESC off. (ESC OFF indicator will illuminate). To turn the ESC on, press the ESC OFF button (ESC OFF indicator light will go off).
  • When starting the engine, you may hear a slight ticking sound. This is the ESC performing an automatic system self-check and does not indicate a problem.

When operating

When the ESC is in operation, the ESC indicator light blinks.

  • When the Electronic Stability Control is operating properly, you can feel a slight pulsation in the vehicle. This is only the effect of brake control and indicates nothing unusual.
  • When moving out of the mud or driving on a slippery road, pressing the accelerator pedal may not cause the engine rpm (revolutions per minute) to increase.

    The Electronic Stability control (ESC) system is designed to stabilize the vehicle during cornering maneuvers. ESC checks where you are steering and where the vehicle is actually going.

    ESC OFF state There are 2 types of ESC OFF states: Traction Control disabled and Traction & Stability Control disabled. If the ignition is turned off when ESC is off, ESC remains off.

    Other information:

    Kia Forte 2019-2024 (BD) Owner's Manual: Side marker bulb replacement (Headlamp Type A,B)

    1. Open the hood. 2. Remove the bulb-socket from the headlamp assembly by turning the bulb-socket counterclockwise until the tabs on the bulb-socket align with the slots on the headlamp assembly. 3. Remove the bulb from the bulbsocket by pulling it out.

    Kia Forte 2019-2024 (BD) Owner's Manual: Stop and tail lamp (LED type) bulb replacement (Rear combination lamp Type B)

    If the stop and tail lamp (LED) (1,2,3) does not operate, have the vehicle checked by an authorized Kia dealer. The LED lamp cannot be replaced as a single component because it is an integrated unit. The LED lamp has to be replaced with the unit.

    Categories

     
    Copyright © 2025 www.kiforte.com - 0.0084