Kia Forte: Manual heating and air conditioning / Temperature control

The temperature will increase to the maximum (HI) by turning the knob all the way to the right.

The temperature will decrease to the minimum (Lo) by turning the knob all the way to the left.

When turning the knob, the temperature will increase or decrease by 0.5°C/1°F. When set to the lowest temperature increments setting, the air conditioning will operate continuously.

Adjusting the driver and passenger side temperature equally

  • Press the “SYNC” button to adjust the driver and passenger side temperature equally.
    The passenger side temperature will be set to the same temperature as the driver side temperature.
  • Turn the driver side temperature control knob. The driver and passenger side temperature will be adjusted equally.

Adjusting the driver and passenger side temperature individually

  • Press the “SYNC” button again to adjust the driver and passenger side temperature individually. The illumination of the button turns off.
  • Operate the driver side temperature control knob to adjust the driver side temperature.
  • Operate the passenger side temperature control knob to adjust the passenger side temperature.

Temperature conversion

You can switch the temperature mode from Centigrade to Fahrenheit as follows:

While pressing the OFF button, press the AUTO button for 3 seconds or more.

The display will change from Centigrade to Fahrenheit, or from Fahrenheit to Centigrade.

If the battery has been discharged or disconnected, the temperature mode display will reset to Fahrenheit.

    The heating and cooling system can be controlled manually by pressing buttons or turning knob(s) other than the AUTO button. In this case, the system works sequentially according to the order of buttons or knob(s) selected.

    This is used to select the outside (fresh) air position or recirculated air position. To change the air intake control position, push the control button.

    Other information:

    Kia Forte 2019-2024 (BD) Owner's Manual: Using the Tire Mobility Kit

    1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast. 2. Filling the sealant: Strictly follow the specified sequence, otherwise the sealant may escape under high pressure.

    Kia Forte 2019-2024 (BD) Owner's Manual: Recharging the battery

    Your vehicle has a maintenance-free, calcium-based battery. If the battery becomes discharged in a short time (because, for example, the headlamps or interior lamps were left on while the vehicle was not in use), recharge it by slow charging (trickle) for 10 hours.

    Categories

     
    Copyright © 2025 www.kiforte.com - 0.0068